Analog Devices Inc.

The ADL5303 is a monolithic logarithmic detector optimized for the measurement of low frequency signal power in fiberoptic systems and offers a large dynamic range in a versatile andeasily used form. Wide measurement range and accuracy are achieved using proprietary design and precise laser trimming.The ADL5303 requires only a single positive supply, VPS, of 5 V. When using low supply voltages, the log slope can be altered tofit the available span. Low quiescent current and chip disablefacilitate use in battery-operated applications.The input current, IPD, flows in the collector of an optimally scaled NPN transistor, connected in a feedback path around alow offset JFET amplifier. The current summing input nodeoperates at a constant voltage, independent of current, with a default value of 0.5 V; this may be adjusted over a wide range. An adaptive biasing scheme is provided for reducing photo-diode dark current at very low light input levels. The VPDB pin applies approximately 0.1 V reverse bias across the photodiode for IPD = 100 pA, rising linearly to 2.0 V of reverse bias at IPD = 10 mA to improve response time at higher power levels. The input pin INPT is flanked by the VSUM guard pins that track the voltage at the summing node. Connecting the exposed pad of the device to the VSUM pins provides a continuous guard to minimize leakage into the INPT pin.The default value of the logarithmic slope at the VLOG output is set by an internal 5 k? resistor. Logarithmic slope can belowered with an external shunt resistor or increased using the buffer and a pair of external feedback resistors. The addition of a capacitor at the VLOG pin provides a simple low-pass filter.The intermediate voltage, VLOG, is buffered in an output stage that can swing to within about 100 mV of ground and the positive supply, VPS, and provides a peak current drive capacity of ?20 mA. An on-board 2 V reference is provided to facilitate the repositioning of the intercept. The incremental bandwidth of a translinear logarithmic amplifier inherently diminishes for small input currents. At IPD =1 nA, the bandwidth of the ADL5303 is approximately 2 kHz increasing in proportion to IPD up to a maximum value of 10 MHz.APPLICATIONS High accuracy optical power measurement Wide range baseband log compression Versatile detector for APC loops

* $138.15 - * $143.92