Pycom

Category: RF and Microwave

Imagine 5 networks in one perfectly-formed IoT development board. Featuring WiFi, Bluetooth, LoRa, Sigfox and dual LTE-M (CAT M1 and NBIoT) the FiPy gives access to all the world’s LPWAN networks on one tiny board.

Get on with a board that gives you full flexibility during testing, install, deployment and even later when you want to switch real-time your airtime network provider. You can switch when the time is right for you or set some parameters that will do so automatically.

Features:

• Powerful CPU
• Five networks: WiFi, BLE, cellular LTE-CAT M1/NB1, LoRa and Sigfox
• 1KM WiFi range
• MicroPython enabled
• Fits in a standard breadboard (with headers)
• Ultra-low power usage: a fraction compared to other connected microcontrollers

Processing:

• Espressif ESP32 SoC
• Dual processor and WiFi radio system on chip
• Networking processor handles the WiFi connectivity and the IPv6 stack
• Main processor is entirely free to run the user application
• An extra ULP-coprocessor that can monitor GPIOs, the ADC channels and control most of the internal peripherals during deep-sleep mode while only consuming 25uA

Interfaces:

• 2 x UART, 2 x SPI, I2C, micro SD card
• Analog channels: 8×12 bit ADCs, 2×8 bit DAC
• Timers: 2×64 bit with PWM with up to 16 channels
• DMA on all peripherals
• GPIO: Up to 22

Memory:

• RAM: 4MB
• Flash Memory: 8MB
• GPIO: Up to 22
• Hardware floating point acceleration
• Python multi-threading

$60.25 - * $90.34