Complete 12-Bit, 100 kHz, Sampling ADC (AD7870/AD7870A) Features: Complete Monolithic 12-Bit ADC with: 2 µs Track/Hold Amplifier 8 µs A/D Converter On-Chip Reference Laser-Trimmed Clock Parallel, Byte and Serial Digital Interface 57 ns Data Access Time 72 dB SNR at 10 kHz Input Frequency (AD7870, AD7875) Low Power: –60 mW typ Variety of Input Ranges: ±3 V for AD7870 0 V to +5 V for AD7875 ±10 V for AD7876

3000 V/S, 35mW Current Feedback Quad Amplifier Features: High speed 250 MHz -3 dB bandwidth (G = +1) 3000 V/µs slew rate 21 ns settling time to 0.1% 1.8 ns rise time for 2 V step Low power 3.5 mA/amp power supply Current (35 mW/amp) Single supply operation Fully specified for +5 V supply High output current of 50 mA Good video specifications (RL = 150 Ω, G = +2) Gain flatness 0.1 dB to 30 MHz 0.04% differential gain error 0.10° differential phase error Low distortion –78 dBc THD at 5 MHz –61 dBc THD at 20 MHz Available in a 14-lead SOIC

160 MHz Rail-to-Rail Amplifier with Disable Features: Fully specified for +3 V, +5 V and ±5 V Supplies Output Swings Rail to Rail Input Voltage Range Extends 200 mV Below Ground No Phase Reversal with Inputs 1 V Beyond Supplies Disable/Power-Down Capability Low Power of 5.2 mA (26 mW on 5 V) High Speed and Fast Settling on 5 V: 160 MHz -3 dB Bandwidth (G = +2) 160 V/µs Slew Rate 30 ns Settling Time to 0.1% Good Video Specifications (RL = 150 Ω, G = +2) Gain Flatness of 0.1 dB to 30 MHz 0.03% Differential Gain Error 0.03° Differential Phase Error Low Distortion -69 dBc Worst Harmonic @ 10 MHz Outstanding Load Drive Capability Drives 50 mA 0.5 V from Supply Rails Cap Load Drive of 45 pF

Triple Differential Driver for Wideband Video Features:Triple high speed fully differential driver700 MHz, 3 dB, 2 V p-p bandwidth (AD8146/AD8148)600 MHz, 3 dB, 2 V p-p bandwidth (AD8147)200 MHz, 0.1 dB, 2 V p-p bandwidth3000 V/s slew rate Fixed gain (AD8146/AD8147: G = 2, AD8148: G = 4) Differential or single-ended input to differential output Can be used as differential-to-differential receiver Drives one or two 100 UTP cables Adjustable output common-mode voltage (AD8146) Internal common-mode feedback network Output balance error 50 dB @ 50 MHz On-chip, sync-on common-mode encoding (AD8147/AD8148) Output pull-down feature for line isolation Low power: 57 mA @ 5 V for 3 drivers (AD8146) Wide supply voltage range: +5 V to 5 V Available in a small 4 mm 4 mm LFCSP

Single-Supply, Low Cost Instrumentation Amplifier Features:Gain set with 1 resistor per amplifierGain = 5 to 1000InputsVoltage range to 150 mV below negative rail25 nA maximum input bias current30 nV/Hz, RTI noise @ 1 kHzPower suppliesDual supply: 2V to 12Single supply: 3V to 24V500 A maximum supply current

Single-Lead, Heart Rate Monitor Front End Features: Fully integrated single-lead ECG front end Low supply current: 170 μA (typical) Common-mode rejection ratio: 80 dB (dc to 60 Hz) Two or three electrode configurations High signal gain (G = 100) with dc blocking capabilities 2-pole adjustable high-pass filter Accepts up to ±300 mV of half cell potential Fast restore feature improves filter settling Uncommitted op amp 3-pole adjustable low-pass filter with adjustable gain Leads off detection: ac or dc options Integrated right leg drive (RLD) amplifier Single-supply operation: 2.0 V to 3.5 V Integrated reference buffer generates virtual ground Rail-to-rail output Internal RFI filter 8 kV HBM ESD rating Shutdown pin 20-lead 4 mm × 4 mm LFCSP package Qualified for automotive applications

10 MHz, G = 1, 10, 100, 1000 iCMOS Programmable Gain Instrumentation Amplifier Features: Small package: 10-lead MSOP Programmable gains: 1, 10, 100, 1000 Digital or pin-programmable gain setting Wide supply: ±5 V to ±15 V Excellent dc performance High CMRR: 100 dB (minimum), G = 100 Low gain drift: 10 ppm/°C (maximum) Low offset drift: 1.2 µV/°C (maximum), G = 1000 See data sheet for additional features

Digitally Programmable Sensor Signal Amplifier with EMI Filters Features: EMI filters at input pins Specified from −40°C to +140°C Low offset voltage: 10 μV maximum Low input offset voltage drift: 65 nV/°C maximum High CMRR: 94 dB minimum Digitally programmable gain and output offset voltage Programmable output clamp voltage Open and short wire fault detection Low-pass filtering Single-wire serial interface Stable with any capacitive load SOIC_N and LFCSP_VQ packages 4.5 V to 5.5 V operation

Ultrafast 7 ns Single Supply Comparator Features: 7 ns propagation delay at 5 V Single supply operation: 3 V to 10 V Low power Latch function TSSOP packages

Quad 12-Bit Serial Voltage Output DAC Features: Guaranteed monotonic over temperature Excellent matching between DACs Unipolar or bipolar operation Buffered voltage outputs High speed serial digital interface Reset-to-zero scale or midscale Wide supply range, +5 V only to ±15 V Low power consumption (35 mW maximum) Available in 16-Lead PDIP, SOIC, and CERDIP packages